X-Can V.2

Here is the latest design in can style exhaust options. If you are looking for torque, then look no further. Brought to you by Team GoNads this can fits G23, G230RC, G2D, and Geo models. Complete with all gaskets, stainless mounting screws, and excellent instructions Adds an extreme amount of low end torque with about 2-3 mph top speed increase.$80.00

X-Can Tune Kit

Are you looking for some more torque, or top end then tune your X-Can with this tune kit. Comes as pictured with 2 sizes of stingers, o-rings, and gaskets. Fits all TGN cans. $12.00

Chrome Elbows

Chrome elbows for all X-Cans. $7.00

GSR/Interceptor X-Can Kit

We all knew it wouldn't be long before famous TGN founder Mark Hull made our GSR's faster. This is the all new GSR X-Can featuring dual outlet, X-Port, and 6-bolt can to prevent any leaking. You can run dual outlet to the rear of the frame, or use the included plug and run one outlet back into the frame to give that stock appearance. Add this to your GSR-40, or your Interceptor and feel the power. $100.00

Small X-Port

Small X-Port to inrease torque slightly. Was designed with the intent to use with a pipe with very little modification. $15.00

Medium X-Port

Medium X-Port, which was the original. Works on all models except the GSR's. Better low end with little or no sacrifice on top speed. $25.00

Large X-Port

Large X-Port was designed for the guy who had to have all the torque available. $25.00

X-Can

Orignal X-Can still being offered. Hollow can allowing maximum exhaust flow. Works on all models except GSR's. Use an optional X-Port for increased torque. If used with optional elbows an X-Port will be required to clear the wing not on Sport based models. No re-packing required. Complete kit comes with stainless screws, gaskets, and instructions. $75.00

Q-Can

Everyone wanted performance with the sound of stock exhaust. With an increase in performence approx 700-1000RPM this can is sure to impress you. Use without X-port and aim included elbow rearward, or use at least a medium X-Port and route the exhaust into the frame as done stock. This is the ultimate in quiet cans. $77.50

ADA Stalker Exhaust System

Billet aluminum finned housing to reduce heat. Packed and baffled for noise reduction. Increases low and mid range power with a 700-1000RPM increase over stock G23 exhaust. Includes stainless sleeve, and mounting harsware. If mounting on a G230RC you may want the spacer, or you can cut the tab from the rear of the fan cover. $85.49

ADA Stalker Spacer

ADA Stalker billet exhaust spacer designed for use with the Stalker exhaust on the RC to prevent from cutting the flywheel cover tab. This item is not required to install. You will be required to cut you flywheel cover if this is not used with the Stalker on an RC engine. You can also use this to lenghten the exhaust chamber for increased torque. $9.50